Husqvarna TA36 Manuale Utente

Operators manualAR19AR25TA36Models:Please read these instructions carefully and makesure you understand them before using the machine.MANUAL NO. 54020

10ASSEMBLY INSTRUCTIONSModel AR191. Wear eye protection. Remove wooden blocks. NOTE: Watch for nails and wood splinters.2. Carefully cut open side of

11AERATION TIPSShould I water before aerating?Best aerating condition is a soft and moist ground. If you are unsure of the ground conditions, as insoi

12THROTTLE CABLE ADJUSTMENT. Model AR25 (Honda Engine Only)1. Start engine and allow it to reach operating temperature.2. Adjust the throttle cable

13REAR WHEEL ADJUSTMENTThe rear wheel depth/stability control knob (see Figure 6) allows adjustment for better stabilityand maneuverability by turning

14When operating on hills you should consider the following:(A) Operate the machine up and down the hills rather than across them.(B) Use the rear whe

15ENGINE SERVICE AND MAINTENANCEFollow the engine manufacturers maintenance instructions. Should any malfunction occur with theengine during the warra

16Engine, Removal and Replacement1. Remove weights for access.2. Remove drive guard.3. Remove V-Belt.4. Remove engine bolts.5. Lift engine from unit.N

17HANDLE - MODEL AR19 ONLYInspection1. The handle cam lock must lock shut under moderately heavy hand pressure. Handle frameshould be tightly secured

18Drive Wheel Shaft Removal and Replacement (Continued)7. Pull sprocket and bearing from shaft. NOTE: Sprocket is double set screwed. To remove thebea

19TINE AND TINE SHAFTTine Replacement1. Turn off engine and remove weights.2. Fold handle on the AR19 Model.3. Note direction of tine bolt.4. Remove a

IndexSection 1 · Operator’s Guide PageSpecifications ...

20What is Aeration?For healthy growth, grass roots need air space in the soil to absorb oxygen, water, and nutrients. Airspace in turf soils is reduce

21TOOLS REQUIRED:2 each 3/4” wrenches1 each 9/16” deep-well socket1 each 9/16” wrenchPARTS INCLUDED:Bolts: 1 each 3/8 x 1 hex w/nut4 each 3/8 x 1 hex

225. Tighten the 1/2” bolt and 3/8” bolt securely.The 3/8” bolt will require the use of a 9/16” deep-well socket wrench to tighten.6. Install tow bar

23AR19AR25AR19AR25

Technical assistance:For technical assistance please contact your Local Dealer.

Operator’s GuideSPECIFICATIONSA) POWER UNIT AR19 AR25Engine 3.5HP Briggs I/C (2.6kw) 3.5HP Briggs l/C (2.6kw)4HP Honda (3kw) 4HP Honda (3kw)C

4MODEL AR19 - FEATURES AND CONTROLSFigure 1Operator’s Guide

5MODEL AR25 - FEATURES AND CONTROLSFigure 2Operator’s Guide

6MODEL TA36 - FEATURES AND CONTROLSOperator’s Guide

7GENERAL INFORMATIONThis manual will assist you in the safe operation and proper maintenance of your Husqvarnaequipment. Read it thoroughly before att

8The following decals are found on Model AR19 and AR25 or TA36 aerators. If any are missing or notlegible, replace them before operating aerator.SAFET

9Throttle CableModel AR25 withHonda OnlyI (On back ofhousing overtine rotor)D2E (on deckbehindengineD1GHJ (For Model AR25)A (For Model AR19)BC (For Mo