Husqvarna 235F Manuale Utente

EEEEnnnngggglllliiiisssshhhh 235R 235FR Oper ator ′ s manual Please r ead the operator’s manual carefully and make sure you understand the instructio

GENERAL SAFETY PRECAUTIONS10 – Englishshould operate the socket spanner when loosening or tightening the nut.The nylon lining inside the locking nut m

GENERAL SAFETY PRECAUTIONSEnglish – 11Check the cutting attachment for damage or cracks. A damaged cutting attachment should always be replaced.Sharpe

GENERAL SAFETY PRECAUTIONS12 – EnglishTrimmer head• Only use the recommended trimmer heads and trimmer cords. These have been tested by the manufactur

ASSEMBLYEnglish – 13Fitting the handlebar• Remove the screw at the rear of the throttle handle.• Slide the throttle handle onto the right side of the

ASSEMBLY14 – EnglishAssembling the cutting equipmentFitting a blade guard, grass blade and grass cutter• Hook the blade guard/combination guard (A) on

ASSEMBLYEnglish – 15CAUTION! Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data. • Fit the drive

ASSEMBLY16 – EnglishFitting other guards and cutting attachments• Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/p

ASSEMBLYEnglish – 17Correct height1 Forestry clearingAdjust the support strap so that the support hook is around 10 cm below your hip. The blade shoul

FUEL HANDLING18 – EnglishFuel safetyNever start the machine:1 If you have spilt fuel on it. Wipe off the spillage and allow remaining fuel to evaporat

FUEL HANDLINGEnglish – 19Mixing• Always mix the petrol and oil in a clean container intended for fuel.• Always start by filling half the amount of the

KEY T O SYMBOLS 2 – English Symbols W ARNING! Clearing saws, brushcutters and trimmers can be dangerous! Careless or incorrect use can result in s

STARTING AND STOPPING20 – EnglishCheck before starting• Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the cent

STARTING AND STOPPINGEnglish – 21Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled.

WORKING TECHNIQUES22 – EnglishGeneral working instructionsBasic safety rules1 Look around you:• To ensure that people, animals or other things cannot

WORKING TECHNIQUESEnglish – 23• Control the felling direction (take advantage of the wind).Working methods• Before you start clearing, check the clear

WORKING TECHNIQUES24 – Englishconditions, so that cleared stems fall in the cleared area of the stand.Forestry clearing using a saw blade• The risk of

WORKING TECHNIQUESEnglish – 25Brush cutting with a saw blade• Thin stems and brush are mown down. Work with a sawing movement, swinging sideways.• Try

WORKING TECHNIQUES26 – English• When trimming and clearing you should use less than full throttle so that the cord lasts longer and to reduce the wear

MAINTENANCEEnglish – 27CarburettorYour Husqvarna product has been designed and manufactured to specifications that reduce harmful emissions. After the

MAINTENANCE28 – English2 Press the start throttle lock as described under the heading Starting and stopping.3 If the start throttle speed is too low (

MAINTENANCEEnglish – 29The grease in the bevel gear does not normally need to be changed except if repairs are carried out.Air filterThe air filter must

CONTENTS English – 3 Contents Note the f ollowing before starting: Please read the oper ator’s manual carefully. KEY TO SYMBOLS Symbols ...

30 – EnglishMAINTENANCEMaintenance scheduleThe following is a list of the maintenance that must be performed on the machine. Most of the items are des

English – 31TECHNICAL DATATechnical dataNote 1: Noise emissions in the environment measured as sound power (LWA) in conformity with EC directive 2000/

32 – EnglishTECHNICAL DATAEC-declaration of conformity (Applies to Europe only)We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, dec

"Clic"12356710118,5 m28'484,2 m14'2,4-2,7 mm.095-.106"10 cm 4"6"15 cmS35

12432,4-2,7 mm.095-.106"4,25 m14'4,25 m14'B6"15 cmA6"15 cmS355

T35, T35x"Clic"12356798,5 m28'484,3 m14'2,4-2,7 mm.095-.106"10 cm 4"6"15 cm

"Clic"123567910 m32'484,3 m14'2,7-3,3 mm.106-.13"10 cm 4"6"15 cmT45, T45x

2,7-3,3 mm.106-.130"15 cm 6"15 cm 6"15 cm 6"15 cm 6"12356710111.)2.)>1,1 Kw<1,1 Kw2,7 mm - 9,0 m3,0 mm

12345678935-50 NM~ 15 cm6'"Clic"~ 3,5 m11 '7,0 m23'2,4-3,3 mm.095"-.130"12 cm5"Trimmy SII

4 – English INTR ODUCTION Dear Customer , Cong ratulations on your choice to buy a Husqvarna product! Husqvarna is based on a tradition that dates

Original instructions´®z+U<J¶6N¨´®z+U<J¶6N¨2010-03-041153284-26

English – 5 WHA T IS WHA T? What is what?272829 1 Blade2 Grease filler cap, bevel gear3 Bevel gear4 Cutting attachment guard5 Shaft6 Handlebar7 Thr

GENERAL SAFETY PRECA UTIONS 6 – English Impor tant Personal protective equipment HELMET A helmet should be w orn if the trees being cleared are tal

GENERAL SAFETY PRECA UTIONS English – 7 BOO TSWear boots with steel toe-caps and non-slip sole.CLOTHINGWear clothes made of a strong fabric and av

GENERAL SAFETY PRECA UTIONS 8 – English be chec ked. See instructions under the heading Maintenance. Stop s witch Use the stop s witch to switch of

GENERAL SAFETY PRECAUTIONSEnglish – 9cutter. Certain harnesses also have a quick release fitted to the support hook.Check that the harness straps are c